Fully custom! Every nut and bolt restoration and customization. Clean CarFax!

Please visit www.Survivor-Cars.com for additional photos, information, and a video. This vehicle is available for viewing by appointment only. Please call us to schedule an appointment. Thousands of hours went into this custom build, with no detail overlooked. Every nut and bolt has been replaced. The frame and body were separated for the restoration and sent to the sand blaster/dipping presses. The body and frame were then sent to get coated in Bullet-Liner along with the bumpers, side armor, full interior and other miscellaneous body panels. Everything is color matched from the gray to the black to the red, inside, out, and underneath! There are less than 10 miles on this amazing build/restoration.
BODY- TNT corner guards, 6” rear flares, Genright 6” front fenders, Quadratec LED tail lights, Smitty built sliders & black diamond bow less top, door hinges, Quadratec fuel kit & Side mirrors, CB antenna and wiring kit, Crown door handles and hardware, RT off-road, heavy duty tailgate hinges, Rugged ridge oversize heavy duty spare tire carrier bracket, Crown tailgate handle and hardware, seal kit, Barricade front trail force winch bumper, Vision x led light pods, Zeke 12,000-lb winch, Factor 55 winch Prolink, Bumper mounted 3/4 shackles, Barricade trail force rear bumper, bumper mounted 3/4 shackles, 1 1/8-9.5 ton bumper hitch mount recovery shackle, 10-piece Empire off-road rock light kit, Energy suspension polyurethane body mount bushings with 1.5 lift, Barnes 4WD frame tie in plates, rear coil, spring to frame relocation bracket, Custom steering shaft brackets & reinforced frame track bar bracket, Poison spider hood vent, Rough country LED halo headlights, Hella super tone horns, DV8 off-road hood latches, Raxiom 50” led light bar, Motobuilt light bar windshield mount.
FRONT SUSPENSION - Yukon 4.56 gears, Detroit lockers, Alloy USA chromoly axle shafts and U-Joints, Moog hubs, TeraFlex sway bar disconnect links and lower control arms, Rubicon express upper control arms, Skyjacker 4” long travel dual rate coil Springs & Black Max long travel shocks, Rugged ridge friend coil spring isolator, Extreme terrain steering box & high pressure steering box line, Steinjager Crossover Steering Kit, Skyjacker steering stabilizer, Falcon clam style tie rod stabilizer mount, Power Stop drilled/slotted rotors and extreme pads, Moog upper and lower ball joints, Artic industries c gussets, industries heavy duty control arm brackets, Truss, side track bar mount, Alloy USA outer tube seals, Rancho diff cover, Rubicon Express track bar & express extended brake lines, Energy sway bar bushings, OPR stainless brake hardline front-back complete, Extreme Terrain extended bump stops, Rough County 2” wheel spacer, Crown upper and lower steering shafts, Tom woods custom driveshaft, Energy Suspension axle side Polly bushings.
REAR SUSPENSION - Yukon 4.56 gears, Detriot Locker, Terraflex lower control arms, Rubicon express upper control arms, Skyjacker 4" long travel coil springs & Long travel shocks, Rubicon express rear track bar & rear extended brake line, Rough country 2" wheel spacers, Crown rear brake rebuild/overhaul kit, Tom Woods custom driveshaft, Alloy USA chromoly axle shafts, National wheel bearings & seals, Rancho diff cover, BF Goodrich tires KO2 35x12.5x15, Pro Comp 51 series wheels, Barnes 4wd heavy duty rear axle bracket kit & Spring keepers, Crown e-brake cables.
POWERTRAIN- Ram Transmission complete transmission & transfer case rebuild, Lux stage 2 clutch, heavy duty flywheel, resealed engine, high volume oil pump with new pick up and screen, ceramic coated intake manifold, Borla headers & Mid pipe, custom exhaust by BDM with 2.5" Dynomax race muffler and matching high flow cat, Crown oil pan, idler pully, tensioner pulley, power steering pump, pulley, Gates serpentine belt, Quadratech fan, HPS silicone radiator hoses, Extreme Terrain thermostat housing, Mishumoto thermostat, Extreme terrain, high pressure steering box line, K&N cold air intake, complete 0 gage neg/pos batter cables and terminals, custom firewall-engine wire harness, Mopar plugs, wires, distributor cap, rotor, block heater, Quadratech motor mounts.
INTERIOR- Pro Car Sportsman suede race seats, matching suede shifter boot, Extreme Terrain inner door handles, OPR complete weather strip, custom matching shift/t-case knobs, Rugged Ridge console lid, Best Top fitted floor mats, Wild Bore grab handles, Rugged Ridge heavy duty arm rests, Tuffy lockable glovebox, Hella wire harnesses for all lights with matching daystar switches, Jensen double din stereo, custom mounted sub box with amps and Monster Wire harness, custom storage box with shovel/recovery boards, fire extinguisher mounted, digital coolant temp gauge, UFO roll cage soft grab handles.
This vehicle is available to view by appointment only. Please call the office to make an appointment. For additional information on this and our other classic and collectible cars for sale, please visit www.Survivor-Cars.com. For assistance, please call the office at 941-845-4461, text our cell phones at 813-358-8830, or email us at info@Survivor-Cars.com. If you are unable to come view the vehicle for yourself, we highly recommend you send in a third-party inspector on your behalf. We are located between Tampa and Sarasota. We are 90 minutes from Orlando and Fort Myers. *Potential purchaser understands it is their responsibility to verify condition and accuracy of information when purchasing from Survivor Classic Cars. It is the sole responsibility of the potential purchaser to inspect the vehicle, or have a third-party inspection performed on the vehicle before purchasing. The potential purchaser is relying solely on their own knowledge and judgement about any vehicle purchased.